Eco Friendly FFP2 Disposable Mask , Personal Safety Valved Dust Mask

Eco Friendly FFP2 Disposable Mask , Personal Safety Valved Dust Mask

1.Cup the respirator in your hand with the nose piece at your finger-tips allowing the headbands to hang freely below your hand.

2.Position the respirator under your chin with the nose piece up.

3.Pull the top strap over your hand resting it high at the top back of your head, Pull the bottom strap over your head and position it around the neck below the ears. Make sure straps are not twisted.

4.Place the fingertips of two hands at the top of the nose piece. Mould the nose piece to the shape of your nose.

5.over the front of the respirator with both hands, sharply exhale and inhale, if air leaks around the nose, readjust the nose clip as described in Step 4, if air leaks at the respirator edges, work the straps back along the sides if the head to eliminate leakage. Repeat the procedure until the respirator fits properly.

Note:

Do not wear with beards or other facial hair that may inhibit contact between the face and the edge of the respirator.

1 . Descriptions

Cup Mask use adjustable aluminum nose clip so it makes wearing more sealless leakage ,use latex-free elastic strap , soft nose liner so it make softer and fit the face .And use easy-breathing valve then it makes breathing more smooth .

FFP2 without valve		FFP2 with valve
Packing:
Box (pcs)	CTN(boxes)	Dimension(cm/ctn)	GW/NW
20	20	54*44*25	6/5

2 . Material of each layer

Outer layer : Protective needle punched cotton
Middle layde : FFP2 melt blown filter(have filter efficiency level of 94%)
Inner layer : Shaped needle punched cotton

3. Directions for use

• The mask is for single use only.
• The mask should not be removed from its packaging until its required for use.
• Use the respirator in accordance with applicable health and safety regulations.
• Fit the respirator and check leak-tightness before entering the contaminated area.
• Wear the respirator for the whole duration of exposure to contaminants.It should not be used for more than 8 hours continuously and should be discarded after use.
• Transport and stockage of unused masks should be such that the product is not stored in direct sunlight and in frost free conditions,not in contact with solvents and cannot be damaged by physical contact with hard surfaces/items.
• As required by European Health and Safety requirements,the user is advised that when the mask is in contact with the wearer’s skin,it may cause allergic reaction to susceptible individuals.If this is the case,leave the hazard area,remove the mask and seek doctor’s advice.​

4 . Expiry date

If maintained as per storage instructions , products can be used up to 5 years from date of manufacture.

5. Advantages

1. FFP2 dust mask has a better design
2. Dual fixed straps, adjustable metal nose band
3. Smooth inner lining ensuring a secure seal.
4. Loaded polypropylene material without any toxic, irritating, stimulant, poison
5. High filtration and static electricity material to resist normal toxic and ting micron particle.